Looking for .338 WM data with H4350 and 225 AB

[Jinete_Palido]

I am working up some loads for the 225 AccuBond in the .338 Winchester Magnum with H4350, and am looking for some data. Any help would be appreciated.

 

[Anonymous]

Call up Mike in customer service, he might have some info for you.
1 (800) 285-3701

 

[lefty315]

See my reply to the other inquiry about .338 Accubonds.

 

[fredj338]

Start w/ 68gr & work up. I liek H4350 & IMR4831 under the 225gr NAB.

 

[john-brennan]

I have two loads that work well with the 225 accubonds in a 338WM, 75gr H4350 for 2900fps, good accuracy around an inch at 100, or my fav. 78gr H4831 for 2950fps and 1 inch or under at 100 yards out of a 24'' barrel.

 

[Richracer1]

my fav. 78gr H4831 for 2950fps and 1 inch or under at 100 yards out of a 24'' barrel.

Please take note that according to the #5 Nosler manual, for a 225grain bullet in a 338 WM, 75grains is the advertised MAX for H4831sc, using a fed 215 primer.

 

[john-brennan]

I have always found the manuals never to be MAX in my rifles, i reload at 1/2 grain increments untill i find signs of pressure then back off 1 full grain off the last load that did not!! show pressure . I have free bore in my 338 but still find with all my guns (ruger77 MII- M700-M70) all well built rifles, manuals are low in pressure with their max loads. I use Win. mag primers.